Friday, January 22, 2010

House Furnace Fan Keeps Blowing On House Furnace?

Fan keeps blowing on house furnace? - house furnace

Williamson has a temperature of oven-o-matic burning oil. Recently published on the oil and had to bleed the line, the furnace is in progress, but now the fan runs continuously and stops shortly after the heating cycle of cold air blowing through the house like it in the basement. near the furnace with the hope that restoration of the work itself, not my other option is to close completely fan.

Posted by Sri Lopes at 12:23 PM

7 comments:

  1. FordmanJanuary 22, 2010 at 4:52 PM

    It seems that the fan is the heater control to the rise of the automobile. If not, then we hope you have a wiring diagram and follow the Power Point to be open to the fans supposed to kill and can then decide to fail.

    ReplyDelete
  2. progunrJanuary 23, 2010 at 12:47 AM

    Make sure you turn on the fan thermostat is not set, must be set to Auto.

    ReplyDelete
  3. progunrJanuary 23, 2010 at 12:47 AM

    Make sure you turn on the fan thermostat is not set, must be set to Auto.

    ReplyDelete
  4. wwwstatJanuary 23, 2010 at 10:56 AM

    He is a fan / limit switch on the oil burner is normally left burning in the oven ... This is bad and needs to be replaced ... costs about $ 30 just to change .. Of course, if the central air in the oven, the thermostat could have created fan auto or fan relay bad place to be .... but I would bet that the fan-limit switch / bad to be

    ReplyDelete
  5. Billy TJanuary 23, 2010 at 7:04 PM

    Place the sensor on the thermostat

    ReplyDelete
  6. avengerg...January 24, 2010 at 3:23 AM

    In the fan / limit switch, a manual, check the in-button, whether it can be found, can be. You should see a white plastic button out, drag it and the fan on auto-drive and the fan runs 24.7

    ReplyDelete
  7. justpoorJanuary 24, 2010 at 1:12 PM

    Sounds like thermostat broken

    ReplyDelete

Subscribe to: Post Comments (Atom)